How a Martin Guitar Is Made, Step by Step

Watch How a Martin Guitar Is Made, Step by Step on YouTube

Watch the video on YouTube

Building a standard Martin guitar takes six to eight weeks, and more complex or ornate models can take up to six months. On a good day the team in Nazareth, Pennsylvania, can build more than 250 guitars, but you can't rush quality. Here's how it's done. (For the story of the company itself, read the birth of the American guitar.)

1. The wood

It all starts with wood, lots of it. The Nazareth factory uses around a quarter of a million board feet of lumber a year, stored in an off-site warehouse. Backs and sides are usually hardwoods like mahogany or rosewood, and tops are spruce. Mahogany arrives in long pieces to be made into backs, sides and necks, while rosewood is processed in the field into back and side sets.

The wood must be dried before it's cut, over several months, using climate-controlled storage and kiln drying. Once cut to workable sizes, it moves to an acclimatising room kept at around 50% humidity and 70°F, with stacks separated by dowels so air can flow and nothing grows mould.

2. Book-matching and candling

The top and back are each made from a single piece of wood split in two. The halves are checked for flaws and matched by colour and grain so the guitar looks symmetrical, a process called book-matching. They're shaved flat and clamped together while the glue dries. Offcuts are recycled or used for small inlay parts.

Tops are then held up to a light to check for hidden knots, a process called candling, after the old practice of inspecting wood by candlelight. Since the wood will be sanded several times, nobody wants nasty surprises later.

3. Cutting and rosettes

Laser cutters cut out each model's shape, saving wood and making the work safer, part of Martin's sustainability efforts. The rosette, the decoration around the soundhole, is cut with a fly cutter, and the trim is inlaid by hand: highly skilled work with specialist tools. It's sanded flush and inspected. Martin uses its own adhesive for binding and rosettes.

4. Bracing

Bracing is one of the most important stages, because it holds the guitar's shape against the considerable pull of the strings. Thin spruce braces are glued to the underside of the top in Martin's X pattern, then shaped by hand with very sharp chisels.

5. Sides, assembly and binding

Matching side panels are softened with heat and steam in a bending press so they can be curved, then glued and clamped at exactly the right angle. A kerfed strip of cedar, notched so it can bend, is glued along the inside edges to join the top and back to the sides. A channel is then routed around the edges for the binding, which protects the guitar from knocks and changes in humidity.

6. Sanding and finishing

The body is sanded repeatedly with progressively finer grits. It's then sprayed with thin coats of nitrocellulose lacquer by a machine arm; too much finish would affect the sound. It cures in a climate-controlled room and is sanded again, then polished in three stages: a robot arm presses it against a wax-loaded buffing wheel (with sensors to stop it pressing too hard), then a smaller wheel, then a hand polish with lamb's wool.

7. The neck

Each neck is marked out with a template and cut roughly on a bandsaw by hand, then finished on a computer-controlled router, and every neck is completed by hand, so each is slightly different. The ebony fretboard is slotted, fret wire is pressed in at the correct height, and the fretboard is glued to the neck, sanded and polished. A steel truss rod inside helps keep the neck straight against string tension and humidity.

For more from my Martin visit, read humidity advice from Martin's repair department. And for another factory tour, see how a Fender Stratocaster is made.

Previous
Previous

Two Bad Guitar Habits I'm Trying to Fix: String Noise and Too Much Slap

Next
Next

Why Your Acoustic Guitar Plays Badly: Humidity Advice from Martin's Repair Department