While I was at Martin HQ in Nazareth, Pennsylvania, I asked the people who do this every day how they actually restring a guitar. These are the hands that prepare instruments played by some of the greatest musicians in the world. My friend Dylan restrings and services guitars all day at Martin, and he showed me exactly how he does it: no shortcuts, no guesswork. I keep coming back to this footage myself, so pause and rewatch as often as you need.
This is the standard headstock version. If your guitar has a slotted headstock, see how to restring a slotted headstock.
1. Seat the bridge pins
Feed the ball end of each string into the bridge hole, with the groove of the bridge pin facing the string. Push the pin down while gently pulling the string up, so the ball end seats snugly against the pin rather than the pin itself. Dylan keeps all the pin grooves facing the same way as neatly as he can. If you removed the saddle, put it back in before tuning up.
2. Line up the tuning posts
Turn each tuning post so the hole runs left to right, at 90 degrees to the string.
3. Leave the right amount of slack
- High strings: pull the string through until there's about an inch of slack at the first fret.
- Middle strings: about half to three-quarters of an inch.
- Low E: the thickest string needs less, around half an inch or even less, so you don't fill the whole post with wraps.
Aim for about two to three wraps per string.
4. The locking wrap
This is the Martin way, though not everyone does it. After threading the string through the post, bring the end back behind and underneath the string, keeping it taut, then over the top. That creates a lock, which makes it much easier to tighten the string without it slipping. It makes taking strings off a bit more of a hassle, but Dylan thinks it's worth it.
5. Trim and wind
Clip the excess as short as you can, taking care not to touch the headstock with your cutters. Then wind the string up to pitch, keeping it firm.
6. Wrap direction
The treble-side strings wrap to the right and the bass-side strings wrap to the left, so each string travels in a straight line from the nut to its post.
That's it. If your guitar still doesn't feel right after fresh strings, it may need a set-up from a good local repairer. For more on guitar care, read inside the Plek machine, and see which strings I use on my Martin.
