When I visited the Martin factory in Nazareth, Pennsylvania, I asked my friend Dylan, who works on guitars day in, day out at Martin HQ, to show me how he restrings them. In the first video we covered a standard headstock. Slotted headstocks are more intricate, more delicate and easier to get wrong. I've been using this exact footage as a reference for my own Martin OM-42, pausing and rewinding step by step, so take your time.
Dylan demonstrates on a Martin 000-15SM. As Dylan explains, the "SM" refers to its side-mounted tuners.
Before you start
- If you're nervous, get help. It's easy to scratch, ding or dent a slotted headstock. If you're uncomfortable, take it to a professional or the shop where you bought it.
- Practise on nylon strings first. They're much gentler and won't scratch the wood.
- Protect the edges. You can put a little low-tack tape on the inside edges of the slots.
At the bridge
It's business as usual. Dylan puts all six bridge pins in at once, keeping each ball end snug against its pin, with the slot in the pin lined up with the slot in the bridge.
The string order
Start with the high E, then go G, B, low E, A, and finish with the D. Working from the outside in keeps the strings you've already fitted out of the way.
Fitting each string
- Line up the hole. Turn the tuner so the hole in the roller is vertical.
- Feed it down, then back up. Thread the string down through the hole, leave some slack, and bring the end back up over the roller.
- Make a kink. Bend the string to hold it in place; strings like to be wiry, and the kink gives you control.
- The Martin locking wrap. Tuck the tail underneath the string and kink it again, firming it with your finger. Be careful but firm so you don't damage the headstock.
- Trim before you wind. On a slotted headstock you clip the tail before winding, leaving only a few millimetres so it can't scratch the inside of the slot.
- Wind away from the tail. Using a string winder, wind so the wraps go to the opposite side from the tail, keeping tension on the string with your fingers the whole time so you don't overshoot the pitch.
How much slack?
Thinner strings can have more slack and more wraps. Thicker strings need less, because the wraps quickly cover the roller. For a middle string like the D, Dylan leaves roughly an inch of slack at the first fret. On the low E, fewer wraps are better than too many.
Which way to wrap
On the strings nearest the outer edges, wrap towards the inside of the slot. If you wrap towards the outside, you can scratch the edge of the headstock. Pairs of strings sharing a roller row wrap in opposite directions.
It's fiddly, but it gets easier with practice. For more guitar care, read about the Plek machine and which strings I use and how long they last.
